PCB Piezotronics IMI SENSORS Swiveler ICP 607A01 Installation And Operating Manual page 18

4
PCB Piezotronics Inc. claims proprietary rights in
the information disclosed hereon. Neither it nor any
reproduction thereof will be disclosed to others
without the written consent of PCB Piezotronics Inc.
METRIC MOUNTING HOLE PREPARATION:

DRILL Ø.199[Ø5.05] .300[7.62] MIN
TAP M6 X 1-6g  .200[5.08] MIN
ENGLISH MOUNTING HOLE PREPARATION:
B
DRILL Ø.218[Ø5.54]  .300[7.62] MIN

TAP 1/4-28 UNF-2B .200[5.08] MIN
SILICONE GREASE
2
FIG 1: A 1/8" HEX ALLEN
KEY IS REQUIRED FOR THE ENGLISH
MOUNTING STUD. A 3MM HEX
ALLEN KEY IS REQUIRED FOR THE
METRIC MOUNTING STUD. APPLY
SILICONE GREASE TO ALL MOUNTING
SURFACES (SEE ARROWS FIG 1 & 2)
A
3.) FOR BEST RESULTS, PLACE A THIN LAYER OF SILICONE GREASE (DOW CORNING #4 OR EQUIVALENT) ON
INTERFACE PRIOR TO MOUNTING.
MOUNTING SURFACE SHOULD BE FLAT TO WITHIN .001[0.03] TIR WITH A MINIMUM 63 [1.6 ] FINISH FOR BEST RESULTS.
2
DRILL PERPENDICULAR TO MOUNTING SURFACE TO WITHIN ±1°
1
4
3
1
1
SILICONE GREASE
FIG 2: TIGHTEN THE
MOUNTING STUD USING
THE ALLEN KEY. TORQUE
THE MOUNTING STUD TO
WITHIN 3 TO 4 FT-LBS.
(4.1 TO 5.4 Nm)
3
2
FIG 3: THREAD THE SENSOR'S
HEX NUT ONTO THE MOUNTING
STUD. POSITION THE CABLE OR
CONNECTOR TO THE DESIRED
LOCATION AND HAND TIGHTEN
THE HEX NUT.
UNLESS OTHERWISE SPECIFIED TOLERANCES ARE:
DIMENSIONS IN INCHES DIMENSIONS IN MILLIMETERS
[ IN BRACKETS ]
DECIMALS XX ±.01 DECIMALS
XXX ±.005
ANGLES  2 DEGREES ANGLES
FILLETS AND RADII FILLETS AND RADII
.003 - .005 0.07 - 0.13
2
REV
B ADDED METRIC MOUNTING INFORMATION
FIG 4: TIGHTEN THE HEX FIG 5: IF FOR ANY REASON THE MOUNTING
NUT USING A TORQUE WRENCH
TO WITHIN 2 TO 3 FT-LBS DISENGAGE FROM THE SENSOR, USE A
(2.7 TO 4.1 Nm) WHILE HOLDING FLAT HEAD SCREW DRIVER
THE CABLE OR CONNECTOR TO HOLD THE STUD WHILE TURNING THE
HEX NUT COUNTERCLOCKWISE
IN THE DESIRED LOCATION.
DRAWN CHECKED ENGINEER
JDM 10/9/14 ECB 10/9/14 DRK 10/9/14
TITLE
X ± 0.3
XX ± 0.13
INSTALLATION DRAWING
 2 DEGREES
MODEL 607 SERIES
1
REVISIONS
DESCRIPTION DIN
43341
B
STUD DOES NOT
WITH A WRENCH.
A
3425 WALDEN AVE. DEPEW, NY 14043
(716) 684-0001 E-MAIL: sales@pcb.com
DWG. NO.
CODE
18551
IDENT. NO.
52681
FULL
SCALE: SHEET 1 OF 1
1