Table of Contents
Advertisement
This is the safety alert symbol. It is used to alert you to
potential injury hazards. Obey all safety messages that
follow this symbol to avoid possible injury or death.
The Dexter Sway Control should only be installed by a
qualified technician.
DSC Mounting Location
Select a location on the trailer to mount the DSC. The location
must be 5 to 10 feet behind the trailer bumper hitch ball and
shielded from road debris. The DSC must be securely fastened
onto a vertical surface that does not flex or move from wind, such
as plastic covers or plastic walls. The center of the DSC (marked
by a red dot on the DSC label shown below) must be positioned
on the "center line" of the trailer and the DSC must be mounted
with the correct side in the UP direction as indicated on the label.
The longest edge of the DSC (as indicated by a red line on the
label) must be mounted parallel to the trailer axle beam(s). See
Figure 1.
M O U N T T H I S E D G E U P
MODULE WIRING
CONNECTOR
ON THIS SIDE
Mount this edge parallel with the trailer axle beams 5 to 10 feet back
CAUTION
!
CAUTION
DSC Trailer Mounting
www.dexteraxle.com
Phone: 574-295-7888
Part No. 058-010-00
MOUNT THIS POINT ON TRAILER CENTER LINE
Wires Trailer Wire Function
Purple Left side electric brakes output
Pink
Right side electric brakes output
White
Trailer battery/frame ground point
Blue
Electric brake controller signal from tow vehicle
Black
12VDC from tow vehicle trailer harness
from trailer bumper hitch ball on a vertical frame surface
Module will not function if
positioned and/or oriented
improperly. Read and
WARNING
follow all Installation Instructions
to ensure proper operation.
Label No. 059-898-00 Rev C
Assembled in the USA by Tuson RV Brakes, LLC.
-3-
Advertisement
Table of Contents
