Using Different Metering Options; Using The Flash - Mercury CyperPix S930X User Manual

Set Up Mode

Using Different Metering Options

" Photo"
1. In the
2. Use [ ][ ][ ][ ] to select "
3. Use [ ][ ][ ][ ] to select the what you want, and then press [Set] button.
Center-weighted average Very limited range in the center of the screen
Pattern
Average

Using the Flash

Perform the following steps to select the flash mode you want to use.
" Photo"
1. In the
2. Each press of [Set] button cycles through the flash mode settings shown below on the LCD
monitor.
3.
Record the image.
Auto
Force Off
Force On
Red-eye
reduction, Auto
NOTE
You may not be able to achieve the desired results using a flash if the subject is too close or
too far away.
About red-eye reduction
Using the flash to record at night or in a dimly lit room can cause red spots inside the eyes of
people who are in the image. This is caused when the light from the flash reflects off of the
retina of the eye. When red-eye reduction is selected as the flash mode, the camera performs
mode, press [Menu] button.
Metering", and then press [Set] button.
Automatic selection of the focus area where the subject
closest to the camera is located
Use this metering method when you want to exert some
control over exposure, without leaving settings totally up to
the camera.
mode, press [Set] button to select the flash mode.
The flash
The flash does not fire.
The flash fires automatically as required by the lighting level.
The flash fires automatically as required by the lighting level,
and the flash pre-strobes before shooting to reduce red-eye
phenomenon.
16