Download Print this page

Knoll SI1X6 Installation Instructions page 3

Six room speaker-stereo interface

Advertisement

Specifications:
Peak RMS power rating: 300 watts per channel (5
seconds)
Continuous RMS power:
Frequency Response:
Speaker types:
Speaker wiring method: Series or parallel wiring is
Speaker impedance:
Grounds
Connection:
Dimensions:
Color:
Note: When using tube or valve amps, we suggest adding 150 ohm 3
watt resistors in parallel across each amplifier left and right output.
150 watts per channel
DC to 500,000 Hz at all power
levels to 350 watts +/- 0.1dB
Most speaker types are
acceptable. Similar and
dissimilar speakers can be used
on one interface and each will
sound their best.
acceptable.
4-16 ohms (single or multi-
speakers)
Independent left/right grounds
for safe connection of all
amplifier types except tube or
valve amps. See below.
Detachable screw terminals
capable of 12-22 awg wire
17" x 12" x 1.75" (43 x 30 x 4.5
cm)
Black
Warranty
Knöll Systems warrants its products sold in the USA and Canada by authorized Knöll
dealers to be free of defects in materials and workmanship. This warranty extends for two
full years from the date of purchase by the original consumer. Any products returned to
Knöll Systems and found to be defective by Knöll Systems within the warranty period
will be repaired or replaced at Knöll Systems option, at no charge. Knöll Systems will not
be responsible for the actual cost of installation or removal of the product, nor for any
incidental or consequential damages. Some states do not allow the exclusion or limitation
of incidental or consequential damages, so the above limitation may not apply to you.
This warranty gives you specific legal rights. You may have additional legal rights that
vary from state to state.
The SI1x6 and SI1x6m have no user replaceable
parts.
Knoll Systems
145 Tyee Drive Point Roberts, WA 98281
11791 Machrina Way, #120 Richmond BC V7A 4V3
tel (604) 272 4555, fax (604) 272 5595
www.knollsystems.com
Made in Canada. SI1x6 guide.doc  1999-2002 Knoll Systems. All Rights Reserved
Note: The SI1x6m connector identification may vary from
this illustration.

Advertisement

loading

This manual is also suitable for:

Si1x6m