Table of Contents
Advertisement
Recharging
Your altimeter has an advanced Lithium Polymer
battery, the same type of battery used in the
latest laptops and cell phones (only much, much
smaller).
It can be recharged in any standard USB port,
including those on computers, printers, and other
devices.
Recharging Directions
1.
If the four silver contacts are dirty, wipe them
clean with a damp cloth
2.
Insert the altimeter into a USB port
3.
The back will glow red or green near the plug
if inserted properly
4.
If unit does not glow when inserted:
a. Make sure computer is turned on
b. Flip the altimeter over and try again
Fully charging the altimeter usually takes about
two hours if the battery is completely discharged.
It does not hurt the battery to leave it in the char-
ger, and it's fine to "top it off " whenever you can.
The battery holds enough charge to power the
altimeter for at least 14 hours of continuous use.
Troubleshooting
Seeing a
red glow
same time would indicate that the battery is
disconnected or damaged. Hopefully, that will
never happen to you.
and a
green glow
jolly logic
at the
Red:
Charging
Green:
Fully
Charged
5
Advertisement
Table of Contents
