Advertisement
STEP 2 for Pendant Mounting –
Attach canopy bracket to a 3-1/2" or 4" octagonal or single gang junction box. Screw pivot ball onto one
end of the pendant stem. Feed AC supply wiring thru the pendant stem and set pivot ball into canopy
bracket (note that there is a slot on the pivot ball that matches a finger on the canopy bracket. This detail
prevents uncontrolled twisting of the exit sign due to breezes, impact, etc.) Slide canopy over pendant
stem and snap onto the canopy bracket. Thread the jamb nut onto the end of the pendant stem followed
by the pendant adapter. Remove the center knockout that is found in the top of the backplate or extra
stencil face (use the extra stencil face for double sided "EXIT" installations – single face installation using
the backplate is shown above). Place the resulting opening in the backplate or stencil over the threaded
nipple on the pendant adapter and thread on the jamb nut. A four pole connector assembly is provided
on the stencil/electronics assembly for AC service connection. Make AC service connections according to
the table below. Snap stencil/electronics assembly to backplate or extra stencil and refer to operating
instructions section.
230VAC
Green Wire - Ground
White Wire - Common
Black Wire – Cap Off
Blue Wire – 230VAC
120VAC
Green Wire - Ground
White Wire - Common
Black Wire – 120VAC
Blue Wire – Cap Off
CAUTION: Unused primary wire must be capped off!
Philips Lighting North America Corporation
200 Franklin Square Drive
Somerset, NJ 08873, USA
Phone: 855-486-2216
www.philips.com/luminaires
Green - Ground
Philips Lighting Canada Ltd.
281 Hillmount Road,
Markham ON, Canada L6C 2S3
Phone: 800-668-9008
www.philips.com/luminaires
9140053550 February 2016
Advertisement
