Download Print this page

Bass Management; Care And Cleaning - Klipsch Icon VB-15 Owner's Manual

Icon series
Hide thumbs Also See for Icon VB-15:

Advertisement

Center Channel Speaker
• Place immediately above or below the center of your video display.
Surround Channel Speakers
• Place approximately 2 feet above seated ear height on side or
rear walls (approximately 5-6 feet above the floor).
• Use the attached wall brackets to hook to appropriately sized
screw heads screwed into a wall stud and wall anchor or two
wall anchors with a suitable weight bearing capacity. (See
Figure 3.)
Connecting
Turn your amplifier off before making any
connections.
• Your loudspeakers are equipped with positive (Red) and negative
(Black) connection terminals on the rear of the cabinet. These
correspond to the positive and negative terminals on the
appropriate channel (left, right, center, rear etc.) of your amplifier.
Standard Connections
• All speakers in your system must be connected in phase with
the positive speaker terminal connected to the positive
amplifier terminal. Repeat this for the negative speaker
terminal and amplifier terminals. Most speaker wire has
distinguishing markings on the insulation of one of the
conductors to assist in correct hookup.
• Use 16 gauge (AWG), two conductor, copper wire at a
minimum and larger gauge wire for longer runs. The
connection terminals on your loudspeaker will accommodate
bare wire, spade terminals, and banana plugs. (After
removing small plastic caps from banana plugs.)
With all connection types, take care that there is no
contact between the positive and negative terminals
at the speaker and amplifier. Damage to your equipment
may result.
VF-36 and VF-35 Standard Connections
• Use either pair of positive and negative terminals keeping the
metal coupling straps in place.
Bi-Wire Connections
(See Figure 5.)
• The VF-36 and VF-35 are equipped with two pair of
connection terminals for bi-wire hookup and enhanced
performance.
• Remove the metal coupling straps; save for later use.
• Connect one speaker wire (+ and -)to the top pair of binding
posts and a second speaker wire (+ and -) to the bottom pair
of binding posts.
(See Figures 2A and 2B.)
(See Figures 2A, 2B and 3.)
(See Figure 4.)(All Models)

Bass Management

When using your speakers in a home theater system, consult
the owner's manual of your surround electronics for proper
application of bass management settings.
• As a general rule, compact speakers (Bookshelf, Center
Channel and Surrounds) are set to the "Small," or bass-
limited setting.
• Floorstanding speakers are typically set to the "Large," or
full-range setting.
• Also refer to the electronics instructions for adjusting the
relative volume levels of the speakers so they are at the same
level when listened to from the primary listening position.

Care and Cleaning

• Occasional dusting or wiping of the cabinet with a cloth
is all that is required. Never use abrasive or solvent type
cleaners or harsh detergents.
• A vacuum cleaner with a soft brush attachment may be used
to clean the grille fabric.
• Never spray polishes or cleaners on the drive units.
Grilles
• Grilles covering the XT
and VC-25 are magnetically attached and removable.
• Grilles covering all woofers on all models as well as the one
piece grille on the VS-14 are non-removable.
3
horn on the VF-36, VF-35, VB-15

Advertisement

loading

This manual is also suitable for:

Icon vc-25Icon vf-35Icon vf-36Icon vs-14