Page 1
125um fiber. to cut the fiber Step 5: Press the LP-F30F tool and then insert the 125 um fiber to reach the Step 6: Move the boot innermost until the buffer make a curve. Then release the tool and check if this toward to the stopper.
Page 2
Step 3: Press the LP-F30F tool to release the buffer and check if they are the same Step 4: Restart the as the chart shows. If it is the same, install the connector again. If the length installing process.
Page 3
CUTTEr MaNUaL and keep 125um fiber. to cut the fiber Step 7: Press the LP-F30F tool and then insert the Step 8: Place the yarn in the slot of both side, then 125um fiber to reach the innermost until the buffer screw the ring.
Page 4
LP-F30F tool, tape the connector. Step 3: Press the LP-F30F tool to release the cable and check if they are the same Step 4: Restart the as the chart shows. If it is the same, install the connector again. If the length installing process.