Advertisement
2
Precautions on Operation
Observe the following precautions for safe operation.
I) Avoid operating or storing the X —Y plotter in a place exposed to direct
sunlight or near a device generating heat.
2) Avoid operating the X —Y plotter in a dusty or humid place.
3) Avoid operating the X—Y plotter in a place with extreme mechanical
vibration or electrical noise.
4) Don't put heavy objects on the X —Y plotter or lean on your arm or
elbow on it.
5) Install the X —Y plotter in as flat a place as possible.
6) Don 't put a magnetic disc, card, or tape on the X —Y plotter, or these
magnetic products may malfunction.
7) Connect the power cable and the interface cable securely. A poor
connection may cause a malfunction.
8) Disconnect the power cable when the X —Y plotter is not used for a
long time.
9) Auto pen cap is provided to prevent drying of the pen point. After
operation,remove the pen from the pen arm and cap it.
10) Don't lubricate mechanical parts. This may cause problems.
11) Use alcohol to remove ink stains from the paper setting table.
Never use an organic solvent such as a thinner.
Special cautions for Electrostatic Paper Holding type.
I ) Electrostatic absorption plate is fitted with electrodes. So, sharp or
edged devices should not be used on the plate in order to protect the
built—in electrodes from being damaged. Putting heavy items on the
plate should also be restrained.
2) Surface of the plastic plate should be free from any dirts, otherwise
absorption power will weaken.
If the surface becomes dirty, sweep a brush over the plate and wipe the
dirt off with a wet cloth.
Water or alcohol is recommended to wet the cloth. Organic solvent
like thinner, however, should not be used to prevent the plastic plate
from deterioration.
3) When transparency film is used as plotting paper, please note it is not
so suitable for electrostatic absorption.
—3
Advertisement
