Ebb Motivate and Flow Motivate Woven Vinyl Rolls Technical Manual Installation · Maintenance · Warranty Manufactured in the U.S.A. by Revised on 22Feb2022 Supersedes all previous versions. Check website for updates and Installation Job Site Conditions Subfloors Subfloor Preparation Storage & Handling...
65°F (18°C) for 48 hours before, during, and after the installation. II. Subfloors 1. Ebb Motivate and Flow Motivate may be installed over concrete, Portland- based patching and leveling materials, and wood. NOTE: Gypsum-based patching and leveling compounds are not acceptable.
Store on a clean, dry, smooth surface. 4. It is normal for Ebb Motivate and Flow Motivate to exhibit light or dark shading, especially at seams. 5. Inspect all materials for visual defects before beginning the installation. No labor claim will be honored on material installed with visual defects.
Page 4
Ebb Motivate and Flow Motivate Technical Manual VI. Installation – Laying out materials 1. Assume that the walls you are butting against are not straight or square. Using a chalk line, make a starting point for an edge of the flooring to follow. The chalk line should be set where the first seam will be located.
Ebb Motivate and Flow Motivate Technical Manual 9. Hand roll all seams after the entire floor has been rolled. 10. Allow adhesive to cure, keeping traffic off the floor for a minimum of 24 hours. Floor should be free from light rolling loads for a minimum of 72 hours.
Protection for flooring from damage and construction debris by using an appropriate floor covering until such time that the recommended initial cleaning may be performed. NOTE: Rubber feet or rubber mats may cause permanent staining to vinyl surfaces. Ecore does not recommend placing equipment with rubber feet or rubber-backed mats on vinyl floors.
4. Periodic Deep Cleaning Depending on the level of traffic, Ebb Motivate and Flow Motivate may require deeper cleaning. If this occurs, warm water extraction is recommended to effectively clean the floor. (DO NOT STEAM CLEAN...
Any defect must be notified to us in writing, and we reserve the right to inspect and investigate any alleged defect. If after this investigation we consider the material to be defective, at the discretion of Ecore, the sole remedy against the seller will be to repair, to replace, or to issue a credit not exceeding the selling price of the defective goods.