MTD 19A30005OEM Installation Manual

Model 19A30005OEM mulch kit is designed for use with select
46-inch two-blade cutting decks. Refer to your lawn tractor's
Operator's Manual to assure compatibility.
Carton Contents
Before beginning installation, remove all parts from the carton to
make sure everything is present. Carton contents are listed below
and shown in Fig. 1-1. Part numbers are shown in parentheses.
• Two 23.25" Mulch Blades (742-04268)
• One 46" Deck Mulch Plug Assembly (631-04327)
Figure 1-1
Installation Instructions
WARNING:
Before beginning installation, place the
tractor on a firm and level surface, set the parking
brake, place the PTO in the disengaged (OFF)
position, stop the tractor's engine and remove the
ignition key to prevent unintended starting.
WARNING: Cutting blades are sharp. Always protect
hands by wearing heavy leather work gloves to
grasp blades.
Printed In USA
I
nstallatIon
46-inch Mulch Kit — 19A30005OEM
MTD LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019
Form No. 3365-293 Rev A
M
anual
1. Remove the cutting deck from beneath the tractor as
instructed in your tractor's Operator's Manual.
2. Gently flip the deck over to expose its underside,
3. Place a block of wood between the deck housing baffle
and the cutting blade to act as a stabilizer, then use a
wrench to remove the hex flange nut that secures each
blade to its spindle assembly. See Fig. 2-1.
IMPORTANT:
The hex flange nuts have a right-handed (normal)
thread pattern. Do NOT attempt to force the nuts in the opposite
direction. Doing so may damage the nut.
Figure 1-2
4. Replace the blades with the blades included in the kit. Be
sure to install each blade with the side marked ''Bottom''
(or with a part number stamped in it) facing the ground
when the mower is in the operating position.
IMPORTANT:
Use a torque wrench to tighten each blade
spindle's hex flange nut to between 70 ft-lb and 90 ft-lb.
Form No. 769-05254
July 21, 2009