Advertisement
Burner tip & opening
Your American Gas Lamp Works Lamp has been installed with an AGLW Gas Lamp
Igniter. Before attempting to operate your Gas Lamp Igniter, it is important to read
the entire product information guide and familiarize yourself with the products
Features and operation.
**Installation of this product must be installed to conform with local codes
or in absence of local codes, with the latest edition of
National fuel gas code ANSI Z21.42-2013 or CSA B140.1 or CSA B149.2
***INSTALLER: PLEASE LEAVE THE PRODUCT GUIDE WITH THE APPLIANCE
FOR THE CONSUMER TO RETAIN FOR FUTURE REFERENCE
GENERAL
The Gas Lamp Igniter provides automated control to a gas lamp burner. The Gas Lamp Igniter controls
the gas flow to a burner, ignites the burner, monitors the flame ensuring burning anytime the gas is
flowing to the burner, senses day/night light levels, and provides a burn timer. The Gas Lamp Igniter
provides continuous burn and night time burn options. This document describes the features and
Operation of the Gas Lamp Igniter.
WARNING! – When the Gas Lamp Igniter is operating and in the ignition cycle (Status LED is Slow Flashing)
a high voltage pulse is generated through the Spark Gap Rod. To prevent risk of electrical shock maintain a
minimum clearance distance of 2 inches from the Spark Gap Rod and Burner.
"AGLW" GAS LAMP IGNITER
PRODUCT INFORMATION GUIDE
Spark Generator
Burner
Flame Sensor
Photo Sensor Eye
1
Advertisement
Table of Contents
Related Manuals for American Gas Lamp Works GAS LAMP IGNITER
Summary of Contents for American Gas Lamp Works GAS LAMP IGNITER
- Page 1 Gas Lamp Igniter. WARNING! – When the Gas Lamp Igniter is operating and in the ignition cycle (Status LED is Slow Flashing) a high voltage pulse is generated through the Spark Gap Rod. To prevent risk of electrical shock maintain a...
- Page 2 FEATURES • Gas Manifold Inlet – Located on the bottom center of the Gas Lamp Igniter. It is a 1/8 NPT Female inlet for connecting the gas supply to. • Gas Manifold Outlet – Located on the top center of the Gas Lamp Igniter. It is a 1/8 NPT Female outlet for connecting the burner to.
- Page 3 • Night LED – Located on side of the Gas Lamp Igniter. Used to indicate if the Night burn mode or Continuous burn mode is activated. The Burn Mode LED is only valid during the Normal Operation mode.
- Page 4 BURNER ALIGNMENT AND SPARK GAP ROD POSITIONING Proper alignment of the Burner and Spark Gap Rod positioning are important to optimal operation. The burner should be installed so that the burner slit is aimed in the direction of the Flame Sensor. Refer to pictures below for optimal alignment and positioning.
- Page 5 • Fault – When a High Voltage or Flame Sensor fault is detected the Gas Lamp Igniter Status LED will be a constant and continuous Fast Flash. The Gas Valve is closed while a fault is detected.
- Page 6 • Burn Timer –In Night Mode, the Burn Timer is used to control how much time after initial ignition the Flame will be maintained for. After the amount of burn time has expired the gas valve is turned off and the Flame extinguished. Burn Timer is reset during the day and re-ignites with the next occurring evening.
- Page 7 TROUBLE SHOOTING Check all electrical connections. Make sure igniter is • connected to the driver(power supply) not directly to IGNITER DOES NOTHING AFTER 120V line INITIAL SET UP • Is the main electric supply "ON" Is the Night LED light solid green? If yes, take it out of night mode by pushing the mode button once and the •...
Need help?
Do you have a question about the GAS LAMP IGNITER and is the answer not in the manual?
Questions and answers