Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for baracuda SUPRA ECO VS
Summary of Contents for baracuda SUPRA ECO VS
- Page 1 SUPRA ECO VS Installation & Operating Instructions...
-
Page 2: Table Of Contents
Baracuda® SUPRA ECO VS | Installation and Operating Instructions Table of Contents Section 1. Important Safety Instructions ..3 Section 4. Maintenance ........ 10 Routine Maintenance ........10 Section 2. Installation ........7 General Maintenance Information ....11 Winterising ............11 Location Requirements ........7 Servicing ............12... -
Page 3: Section 1. Important Safety Instructions
These requirements are generally not intended to apply to the pool equipment, such as filters or pumps. Baracuda pool equipment is pressure tested at the factory. If, however, the WARNING cannot be followed, pressure testing of the piping system must include the filter and/or pump. - Page 4 • Water temperature for test must NOT EXCEED 35°C (95°F). • Limit test to 24 hours. After test, visually check system to be sure it is ready for operation. NOTICE: These parameters apply to Baracuda equipment only. For non-Baracuda equipment, consult the equipment manufacturer.
- Page 5 Baracuda® SUPRA ECO VS | Installation and Operating Instructions WARNING The following guidelines provide information for pump installation that minimizes risk of injury to users of pools, spas, and hot tubs: Entrapment Protection - The pump suction system must provide protection against the hazards of suction entrapment.
- Page 6 • The distribution or modification of this document in any way is prohibited, without prior authorisation from Baracuda. • Baracuda is constantly developing its products to improve their quality. The information contained herein may therefore be modified without notice. WARNING •...
-
Page 7: Section 2. Installation
• This appliance is compatible with all types of water treatment used in swimming pools. Refer to the Baracuda warranty conditions for details of the permitted water balance values. • Never run the pump dry or out of the water as this will void the warranty. -
Page 8: Electrical Connection
Baracuda® SUPRA ECO VS | Installation and Operating Instructions Section 3. Operation • Check that the hydraulic corrections are correctly tightened and that there are no leaks. WARNING • The pipes must be supported to prevent any NEVER run pump dry! Running pump dry may... -
Page 9: User Interface
Baracuda® SUPRA ECO VS | Installation and Operating Instructions • Check that the pump is stable and level. • The hydraulic circuit must be bled and not contain any foreign bodies. • The pump pre-filter strainer cover must be correctly closed (by hand) and its gasket clean and in place. -
Page 10: Pump Shutdown And Reset
Baracuda® SUPRA ECO VS | Installation and Operating Instructions • When the pump is running, it displays the lid cover. Replace lid cover on housing; turn operating speed and an LED lights up above clockwise to tighten cover. the key which corresponds to the speed. -
Page 11: General Maintenance Information
Baracuda® SUPRA ECO VS | Installation and Operating Instructions Follow instructions below to clean leaf basket: • Note that certain parts are subject to normal wear and tear, even when used properly and Stop pump, close gate valve in suction and... -
Page 12: Servicing
Baracuda® SUPRA ECO VS | Installation and Operating Instructions Section 5. Repair Parts • If the pump is positioned below the water level, close the isolation valves at suction Refer all service to your local agent or dealer as and discharge. -
Page 13: Section 6. Troubleshooting
Baracuda® SUPRA ECO VS | Installation and Operating Instructions Section 6. Troubleshooting • If a problem occurs, before you contact your retailer, please carry out these few simple checks using the following tables. • If the problem continues, contact your retailer. -
Page 14: Error Codes
Baracuda® SUPRA ECO VS | Installation and Operating Instructions Error Codes The interface control panel has a digital display and red error display LED to indicate operation issues. Normal operation is indicated by a single flash of this LED upon startup. -
Page 15: Section 7. Pump Parts
Pump Footpiece Assembly NOTE: For any further enquiries or troubleshooting advice, please contact your local authorised Baracuda dealer. Alternatively contact Baracuda customer service on 1300 784 423 or www.baracuda.com.au An electronic copy of this manual may be found on www.baracuda.com.au... - Page 16 Record your equipment details here for quick reference: Model No. : _______________________________________ Serial No. : _______________________________________ Baracuda is a registered trademark of Fluidra Group Australia Pty Ltd ABN 87 002 641 965 219 Woodpark Rd, Smithfield, NSW 2164 Australia Tel: 1300 784 423 www.baracuda.com.au...
Need help?
Do you have a question about the SUPRA ECO VS and is the answer not in the manual?
Questions and answers