Download Print this page

Virtualfly TQ6 User Manual

TQ6 & TQ6+

USER'S MANUAL

Rev 2.0 - September 2021

1. IN THE BOX

A) TQ6 / TQ6+

B) Clamp

C) Allen Screws

D) Allen Key

For support visit help.virtual-fly.com

or contact us at support@virtual-fly.com

All trademarks and brand names are

trademarks or registered trademarks of their

C. Maria Aurèlia Capmany, 21

P.I. La Fàbrica – 08297 Castellgalí (Spain)

Phone: (+34) 983 333 301

www.virtual-fly.com

Table of Contents

Do you have a question about the TQ6 and is the answer not in the manual?

Page 1 TQ6 & TQ6+ USER’S MANUAL Rev 2.0 - September 2021 1. IN THE BOX A) TQ6 / TQ6+ B) Clamp C) Allen Screws D) Allen Key For support visit help.virtual-fly.com or contact us at support@virtual-fly.com © 2021 Virtual Fly, SL C.
Page 2 Finally, connect the USB cable to the computer where the (1) on the backside or (2) on the bottom side. If setting the flight simulation software is running. clamp on the bottom side, make sure you unscrew the two front rubber feet before. TQ6 & TQ6+ | User’s manual...
Page 3 You can do so by turning the knobs, K or J, as seen in the picture, on the left and right sides of the TQ6/TQ6+. Once you have adjusted the knobs, move all the levers, from top to bottom, at the same time at least ten times.
Page 4 The TQ6/TQ6+ interacts with any computer as a joystick (HID), so it is compatible with any flight simulation software. If your device is a TQ6, make sure to calibrate Below, you have two options for setting up your TQ6/TQ6+ the device in VFHub. For more details, check with the most popular flight simulation software: MSFS, the VFHub user’s manual at https://downloads.
Page 5 Please note that reverse zones do not work if you do not use VFHub. MSFS If you own a TQ6+, your device is ready to be used in MSFS. X-Plane If you have a TQ6, don’t worry, you only need to calibrate it If you own a TQ6+, your device is ready to be used in on Windows/MacOS/Linux first.

Tq6+