Honeywell W14L0694 User Manual page 7

9ft 800ct whistler fir prelit
Table of Contents

Advertisement

U
S
E
R SERVICING INSTRUCTIONS (
1. To reduce the risk of overheating, replace burned-out lamps promptly. Use 3.0
Volt, 0.06 Watt LED lamps only.
change the direction of the LED lamp in the lamp holder.
2. Risk of fire. This product does not contain lamp shunts, which allow the
to operate if one lamp burns out. Replace lamps only with the spare lamps
provided with this product.
If the new lamp base does not fit in lampholder, follow the steps below before step 4:
a) Pull the reflector out.
b) Remove the base of burned out lamp by straightening lamp leads and gently
pull lamp out.
c) Thread leads of new lamp through holes in old base with one lead in
each hole.
d) After lamp is fully inserted into base, bend each
lead up, like other lamps in the light set so that the
leads will touch the contacts inside the
lampholder (always match the long lead of new
lamp to the hook of lamp base).
e) Insert the reflector into the base.
CAUTION
a) To reduce the risk of electric shock, use only with the power-supply cord provided or
with a cord set intended for indoor use.
b) Do not use a cracked, frayed, or damaged cord. Inspect the cord periodically.
c) Do not abuse cord - Do not carry product by the cord or yank or pull it to disconnect
from the outlet.
d) Disconnect the product from the outlet when not in use.
e) Do not overload. Connect other lighting strings or tree toppers end-to-end up to a
maximum of 216 watts (1.8 Amps) total. Do not interconnect low-voltage products.
USE AND CARE INSTRUCTIONS
a) Before using or reusing, inspect product carefully. Discard any products that have cut,
damaged, or frayed wire insulation or cords, cracks in the lampholders or enclosures,
loose connections, or exposed copper wire.
b) When storing the product, carefully remove the product from wherever it is placed
to avoid any undue strain or stress on the product conductors, connections, and wires.
c) When not in use, store neatly in a cool, dry location protected from sunlight.
The LED lamp has polarity. Do not deliberately
EN
7
C
O
N
I T
N
U
E
D
)
product

Advertisement

Table of Contents
loading

Table of Contents