Honeywell 9ft 800ct Whistler Fir Prelit User Manual Read and save these instruction before use W14L0694 CAUTION! ALWAYS UNPLUG YOUR TREE FROM ITS POWER SOURCE BEFORE ASSEMBLING OR DISASSEMBLING.
THANK YOU Thank you for purchasing The 9ft Honeywell Whistler Fir LED One Plug tree. This tree assembles in minutes and is decorated with LED light sets. For your convenience, it is equipped with a foot pedal switch for easy illumination.
INSTALLATION Note: Before you start to assemble your tree, please choose a location near an electrical wall outlet. Place the tree stand on a level surface. Please remove protective covers from the base of the pole from each section. 1. Unfold the tree base to a 90 degree angle. 2.
TROUBLESHOOTHING If any lights do not work on your pre-lit tree, please check the following before calling customer service: 1. If entire tree or a section of the tree does not light: a) Make sure the end connector of the power cord is well connected to the bottom section (D).
USER SERVICING INSTRUCTIONS Replace the fuse: A) Replace the fuse of extension cord with foot pedal switch (1 replaceable 5 A, 125 V fuse is located in the plug): Note: This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug.
R SERVICING INSTRUCTIONS ( 1. To reduce the risk of overheating, replace burned-out lamps promptly. Use 3.0 Volt, 0.06 Watt LED lamps only. The LED lamp has polarity. Do not deliberately change the direction of the LED lamp in the lamp holder. 2.
#p6 for a complete list of patents. ARCHWAY MARKETING SERVICES DEPT 4599, CAROL STREAM, IL 60122 4599 866-205-9854 Made in Cambodia The Honeywell Trademark is used under license from Honeywell Dongguan Newone Trading Co., Ltd. International Inc. 1001 Room, No.273, Jinxiu Road, Honeywell International Inc.