Vermason 222635 Application, Operation And Maintenance Manual

EUROPE
Analogue Surface Resistance Test Kit
Operation and Maintenance
Figure 1. Vermason 222635
Resistance Test Kit

Description

The Vermason Analogue Surface Resistance Test Kit
is a portable battery-powered instrument designed to
measure resistance point-to-point (Rp-p) and surface to
ground (Rg). The meter is equipped with an automatic
test voltage selector. The test voltage will switch from
10 V to 100 V should the measured resistance exceed
1 x 10 ohms.
5
ESD protected area products should be tested:
A. Prior to installation to qualify for listing in user's ESD
control plan. Approved ESD materials (see product
qualification table at EN 61340-5-1 Table 3 EPA
requirements).
B. During initial installation.
C. For periodic checks of installed products as part of
EN 61340-5-1 Compliance Verification testing per
EN 61340-2-3.
TB-7572 Page 1 of 3 July 2018
TECHNICAL BULLETIN TB-7572
Analogue Surface
DESCO EUROPE - 2A DUNHAMS LANE, LETCHWORTH, HERTFORDSHIRE, SG6 1BE, UK
Phone: +44 (0) 1462 672005 • E-mail: Service@DescoEurope.com, Website:
Compliance Verification Plan
"A compliance verification plan shall be established to
ensure the organization's fulfilment of the requirements
of the plan. Process monitoring (measurements) shall be
conducted in accordance with a compliance verification
plan that identifies the technical requirements to be
verified, the measurement limits and the frequency at
which those verifications shall occur. The compliance
verification plan shall document the test methods
used for process monitoring and measurements. If the
organization uses different test methods to replace
those of this standard, the organization shall be able
to show that the results achieved correlate with the
referenced standards. Where test methods are devised
for testing items not covered in this standard, these shall
be adequately documented including corresponding
test limits. Compliance verification records shall be
established and maintained to provide evidence of
conformity to the technical requirements. The test
equipment selected shall be capable of making the
measurements defined in the compliance verification
plan." (EN 61340-5-1 clause 5.2.4)
The Analogue Surface Resistance Meter and its
accessories are available as the following item numbers:
Item Description
222635 Analogue Surface Resistance Test Kit (Test
Leads and Electrodes Included)
222637 Analogue Surface Resistance Meter
222636 Shielded Test Leads
222634 Electrodes, 2.27 kg

Packaging

222635 Analogue Surface Resistance Test Kit
1 Analogue Surface Resistance Meter
1 9 V Alkaline Battery
2 Shielded Test Leads
2 2.27 kilograms Electrodes
1 Plastic Carrying Case
1 Certificate of Calibration
222637 Analogue Surface Resistance Meter
1 Analogue Surface Resistance Meter
1 9 V Alkaline Battery
1 Certificate of Calibration
DescoEurope.com
Made in the
United States of America
© 2018 DESCO INDUSTRIES INC
Employee Owned