Hardi 3570 Manual page 8

Actual application rate
HARDI PILOT
L
Reading of total area treated and total volume sprayed
HARDI PILOT
L
Reset of total area treated and total volume sprayed
Area and volume sprayed can be reset by pressing the accept key [
continually. After approx. 5 seconds, the totals are zeroed. As long as
the area and liquid symbols are flashing in the display, it is possible to
regret, by releasing the accept key [
8
135
HARDI
69.2
t o t
376 l
HARDI
The actual quantity applied per area unit is
shown when driving.
On the same display area, the flow rate is
shown when not driving.
The area treated with the corresponding
volume sprayed since the last reset can be
read off. Press accept key [
about 5 seconds, the totals for the area
treated and the volume sprayed since the
last reset will be shown in the display.
NOTE: The total area treated and total
volume sprayed is updated in the non-volatile
memory for every 0.5 hectares / 1 acre.
The display can show a maximum of 9999
units sprayed. If this is exceeded [
and [ ≡ ≡ ≡ ≡ ] will be shown.
].
] briefly. For
L L G G
] / [ ]
]