Advertisement
Quick Links
Advertisement
Summary of Contents for Knightsbridge AMLEDBS
- Page 1 INSTALLATION & MAINTENANCE MANUAL AMLEDBS / AMLEDWS...
-
Page 2: General Instructions
These instructions should be read carefully and retained after installation by the end user for future reference and maintenance. These instructions should be used to aid installation of the following products: AMLEDBS / AMLEDWS SAFETY • This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (BS7671) and current Building Regulations. - Page 3 to infringe with any gas/water pipes or electrical cables Drill out one of the 20mm drilling guides on the fitting, and fit a suitable external grommet or compression gland (not included) Connect the luminaire to the mains supply ensuring the correct polarity is observed: L - Live (brown), •...
-
Page 4: Daylight Sensor
Hold time Daylight sensor Hold time Hold time Daylight sensor Daylight sensor Daylight sensor WARNING WARNING This product must be disconnected from the circuit if subjected to any high voltage or insulation resistance WARNING testing. Irreparable damage will occur if this instruction is not followed. This product must be disconnected from This product must be disconnected from the circuit if subjected to any high voltage or i testing. -
Page 5: Warranty
Clean the external surfaces with a damp cloth using a mild solution of detergent and warm water only, do not use aggressive cleaning products or solvents which may damage the product. Do not use any source of high-pressure washers to maintain or clean this luminaire. This product is non-dimmable. - Page 6 Manufacturers Declaration of Conformity For ML Accessories (Knightsbridge) Electrical products in accordance with CE marking ML Accessories Ltd. Declare that all products have been designed, manufactured, and tested in accordance with the requirements of the relevant legislation CE marking legislation...
- Page 7 Manufacturers Declaration of Conformity For ML Accessories (Knightsbridge) Electrical products in accordance with UKCA marking ML Accessories Ltd. declare that all products have been designed, manufactured, and tested in accordance with the requirements of the relevant legislation UKCA marking legislation UK SI 2016 No.
- Page 8 Supplied By: (UK) Manufacturer ML Accessories Ltd, Unit E Chiltern Park, Boscombe Road, Dunstable LU5 4LT, www.mlaccessories.co.uk (EU) Authorised Representative nnuks Holding GmbH, Niederkasseler Lohweg 18, 40547 Düsseldorf, Germany, Email: eprel@nnuks.com ML Accessories Limited LU5 4LT www.mlaccessories.co.uk DCJUL22_V3...