Summary of Contents for Larson Electronics MTPC-SCHD Series
Page 1
OPERATION AND INSTALLATION MANUAL STATIC PHASE CONVERTERS (MTPC-SCHD Series) WARNING: To reduce the risk of injury, the user must read and understand the operator’s manual before using this product. Version 1 Created on 07/02/21...
Page 2
MTPC-SCHD Series Thank you for your purchase of a Larson Electronics MTPC-SCHD series static phase converter. WARNING Standard Warning (General) WARNING: READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE. CRITICAL SAFETY INSTRUCTIONS: • INSTALLATION SHOULD ONLY BE CONDUCTED BY A QUALIFIED ELECTRICIAN IN ACCORDANCE WITH NEC AND ANY RELEVANT LOCAL BUILDING CODES.
Page 3
MTPC-SCHD Series Introduction and Installation Notes HIGH VOLTAGE – Risk of Electrical Shock. This equipment is connected to line voltage that can create a potentially hazardous situation. Always make certain power is off before servicing this equipment. • • Do not connect control circuits to T3.
Page 4
Wire Method #2 (Idler Motor Method) Single Phase Power Three Phase (Fused or Circuit Motor Starter Three Phase Breaker Protected) or Switch Motor Load Static Phase Converter Idler Motor Larson Electronics, LLC Phone: 877-348-9680 Fax: (903) 498-3364 www.larsonelectronics.com 3 of 10...
Inspect for good working condition prior to storage and before re-use. REPLACEMENT PARTS The MTPC-SCHD series is designed to provide years of reliable performance. Should the need for replacement parts arise, please contact Larson Electronics.
Never turn the single-pole switch to the “ON” position while the Idler Motor is running. Doing so could do damage to the converter. Larson Electronics, LLC. 220V 9419 US-HWY 175 SINGLE Kemp, Tx.
MTPC-SCHD Series TROUBLESHOOTING PROCEDURES As with any troubleshooting procedure, there is no substitute for a clear understanding of the installation procedures involved. The contents of this manual should be studied and THOROUGHLY UNDERSTOOD. Make absolutely certain that all factory installation procedures regarding physical mounting, protection from foreign material, wire sizing, fuse protection, etc., have been followed.
Page 9
Install an idler motor into the circuit. 4. Motor is running A. Improper rotation. 1. Line leads are hooked up wrong for proper rotation. Reverse any two lines 8 of 10 Larson Electronics, LLC Phone: 877-348-9680 Fax: (903) 498-3364 www.larsonelectronics.com...
Page 10
Solutions Are: a. Upgrade your installation to a Rotary Phase Converter. b. Install an idler motor into the circuit. 9 of 10 Larson Electronics, LLC Phone: 877-348-9680 Fax: (903) 498-3364 www.larsonelectronics.com...
If at any time you experience a popping sound, see smoke or liquid coming from within the converter, you can assume that the converter has internal damage and will have to be returned to the factory for repair. 10 of 10 Larson Electronics, LLC Phone: 877-348-9680 Fax: (903) 498-3364 www.larsonelectronics.com...