Operating Your C200/300; Turning On Unit; Operation; Maintenance - C-ITRONE C 200 Manual

3 Operating Your C200/300

3.1 Turning on Unit C200/300
Illustration 1 | Start Buttons
Press the green button to turn on and turn off the unit.
Press the blue button to turn on and turn off the suction
hose.
Illustration 2 | For C300 –
Power Inverter Levels
Level 1 = normal power operation / Level 2 = Standby/ Energy-
Saving Mode. The green and blue buttons will blink when the unit
is in standby mode. To power the unit on, press and hold down the
green but-ton (Power On) until the flashing green light turns to a
constant green light, then press the green button once more. Press
the blue button to activate the unit pulse.

3.2 Operation

Illustration 3 | Distributor Box
Open distributor box; use the blue wheel to set the
machine's operating time. The op-erating time can be
set anywhere from 1-7 minutes (7 minutes equaling a
total of 105 full cycles). Placed directly above the blue
wheel is a blue toggle-switch: the circular symbol
shows the number of full cycles se-lected by user; the
lightbulb symbol shows an infinite number of time-
cycles.
From left to right:
▪
FI-LS button releases in the event of a short-circuit
▪
Release-button T releases the FI-LS button
▪
LP8 = Cycle settings (output capaci-ty)
▪
3 seconds = Suction/ 1.5 seconds = Standby/ 35
seconds = Complete cycles (may be adjusted)
▪
Electrical power surge protector
▪
Eltako (timer) should only be oper-ated by an
authorized C-ITRONE service
Infringement and/or violation of this unit voids all
warranties and/or guarantees on this unit.

3.3 Maintenance

Illustration 4 | Filter
Maintenance should be performed on the C-Itrone 200/
300 unit at least every two years. Please make sure to
set up a maintenance appointment within the re-quired
time frame by emailing: service@c-itrone.com
Please contact the email address above with any
questions or concerns regarding problems or
troubleshooting of this C200/C300 unit.
Per Requirement DGUV Regulation 3, a yearly
Inspection must be completed on units C200 and C300.
Illustration 5 | Switch for permanent vacuum.
Use the dial, pictured in the illustration, to turn on the
technician.
constant-suction function if needed during a treatment.
C-ITRONE 200/300 | 5