Charging The Batteries; Appendix A: Troubleshooting - Keyspan VP-24A User Manual

2. Move back within the USB dongle's range.
3. Press any key to recovery from Sleep mode.
4. Check the connection icon

4.6 Charging the Batteries

 Plug the small connector on the supplied USB charging cable into the USB
connector port on the bottom of your phone.
 With your computer turned on, plug the other end of the cable into a USB
connector on the computer, the phone will begin recharging automatically.
 The charging indicator appears on the display, you can make/receive calls
while charging.
 When the charging indicator stays in full charge
Note: The charging time depends on the battery discharging condition, load and the
temperature, it takes approximately 5 hours to full charge the batteries.

Appendix A: Troubleshooting

This appendix provides common problems and solutions that may occur during the operation of
the phone, whenever you have problems with your phone, please check the followings first:
The phone's power is turned on and the volume control is normal.

The USB dongle is properly connected to the PC.

Make sure that you have a phone signal (the phone signal strength

at least 1 segment showing), if the indicator shows
closer to the USB dongle, and check your PC is connected to Internet.
1. There is no sound when you pick up a call.
is displayed.
remove the charging cable.
, please try to move the phone
34
should have