Markem Imaje SmartDate X40 Instruction Manual page 5

Safety instructions
■ Health / Hygiene / Environment
Solvent-resistant gloves and safety goggles are recommended
during cleaning operations.
Please read the Isopropanol Safety Data Information prior to using
Isopropanol with any Markem-Imaje product.
Noise levels:
Test Standard BS EN ISO 3746:1996
SmartDate X40 Intermittent Mode 199 ppm with a 10 mm Image
(600 mm/s) <70 dB (A)
SmartDate X40 Continuous Mode 275 ppm with a 10 mm Image
(130 mm bag) (600 mm/s) 70 dB (A)
Operating environment of:
32o F to 104o F(0o C to 40o C)
■ Installation Requirements
Ensure that these services and control signals are available:
Power - 100 - 230V AC (+/- 10%) 50 - 60 Hz
Compressed Air - 6 Bar (max.), dry and uncontaminated.
A Print Go Signal - This can be either a volt free contact which
closes when printing is required, or a 24 V DC signal from a PNP
sensor (positive edge triggered).
Sufficient space for installation and operation.
SmartDate X40 configured as a continuous printer also requires
an encoder to monitor the substrate speed.
Instruction manual
5