Advertisement
Operation
CAUTION: If the optional casters are used, make
sure they are locked in place.
To tilt table:
1.
Pull out left and right handles and rotate them 90-
degrees to keep them disengaged.
2.
Begin tilting front edge of table downward until it
just clears the handle pins, then turn handles 90-
degrees and allow them to slide back in.
3.
Continue to tilt table slowly, while helping
stabilize the machine(s), until table passes the
beveled pins at the rear and snaps into level
position.
mounted to table, tilt table slowly and help
stabilize the machines throughout the tilt
process. Do not allow the table to swing
uncontrollably. Failure to comply may cause
personal injury and/or unnecessary stress
upon stand components.
Machine selection
The stand will accept most bench top machines up to
load capacity and within the table size range (see
specifications). Secure the machine to the table with
appropriate fasteners (not provided). Make sure
machine(s) are securely fastened before attempting to
tilt the table.
Position of machines upon the table is user's choice;
however, consideration should always be given to the
machines' center of balance and weight distribution.
Ideally, they are centered upon the table. But the
design of some machines may require them to be
shifted off center for optimum position and/or easier
tilting to the down position.
The 728200 Flip-Top Stand will accommodate most bench top machines, including the following models:
Brand
Model
13" Planer
JET
8" Jointer/Planer
JET
8" Grinder
JET
JET
1020 Drum Sander
9" Belt/Disc Sander
JET
Spindle Sander 5"
JET
18" Scroll Saw
JET
22" Scroll Saw
JET
10" Miter Saw
JET
12" Miter Saw
JET
JET
JET Mortiser
Powermatic
PM Mortiser
10" Band saw
JET
12" Drill Press
JET
15" Drill Press
JET
Powermatic
PM1250 Air Filtration
When
machines
are
Stock No.
722130
707400
726101
723510
708595
708404
727300B
727200B
707210
707212
708580
1791310
714400
716000
716200
1791250
(machines and user-made shelf not provided)
Specifications for JET Flip-Top Stand
Stock number
Table size (D x W)
Height range
Height adjustment
Load capacity
Table material
Assembled weight
Shipping weight
Notes
Secure miter arm before tilting underneath.
Secure miter arm before tilting underneath.
Remove handle if needed before tilting underneath.
Remove handle if needed before tilting underneath.
4
728200
20 x 25 in. (508 x 635 mm)
29 to 34 in. (736.6 to 863.6 mm)
5.10 in. (130 mm)
300 lb. (136 kg)
MDF/Vinyl
45 lb. (20 kg)
49 lb. (22 kg)
Advertisement
