Jet 728200 Instructions And Parts List

728200 Flip-Top Stand
Instructions and Parts List
IMPORTANT SAFETY INSTRUCTIONS
•
Review all instructions before assembling the table.
Improper assembly can cause personal injury and/or
property damage.
•
Do not exceed maximum load for the stand.
•
Do not stand on this product.
•
WARNING: This product can expose you to
chemicals including lead and cadmium which are
known to the State of California to cause cancer and
birth defects or other reproductive harm. For more
information go to http://www.p65warnings.ca.gov.
Tools required for assembly
10mm and 16mm wrenches
(a manual ratcheting socket wrench will speed
assembly time)
Shipping contents
1 Table Assembly
4 Lower Braces (2 Long, 2 Short)
4 Vertical Legs
4 Adjustment Legs
4 Leveling Pads
1 Instructions and Parts List
1 Product Registration Card
1 Hardware Package (728200-HP)
44 Carriage Bolt M6-1.0x16 – AA
44 Flat Washer 6mm– BB
44 Lock Washers 6mm –CC
44 Hex Nut M6-1.0–DD
JET
427 New Sanford Road
LaVergne, Tennessee 37086
Ph.: 800-274-6848
www.jettools.com
Assembly instructions
Use the exploded view and parts list as guides to
assembly. Make all leg and brace fasteners only
finger tight until the entire unit has been assembled.
1. Turn table assembly upside down; use a mat or
piece of cardboard underneath to prevent
scratching.
2. Assemble the four main legs (#20) to the table
brackets (#8/26). Finger tighten only.
3. Determine the height desired, then connect the
adjustment legs (#21) to the main legs. These
can be repositioned later if needed. (It is
recommended that each adjustment leg be
secured by at least 4 screws to the main leg.)
4. Determine placement of lower braces (#24/25)
and assemble them to the main legs/adjustment
legs.
5. Install the leveling foot pads (#22) and tighten
each hex nut (#23) against the adjustment leg. (If
using the optional swivel casters, install those
instead of the pads.)
6. Turn the unit over and push down lightly to make
sure stand rests evenly upon the floor.
7. Fully tighten all fasteners.
overtighten.
Holes are provided in the lower braces for attaching a
user-made shelf, not provided.
Take care to not
Part No. M-728200
Edition 2 03/2022
Copyright © 2022 JET