Branch exchange series
sip 3cx based private
branch exchange (37 pages)
Summary of Contents for Patton SmartNode Branch eXchange Series
Page 1
Important—This is a Class B device and is intended for use in a light industrial or residential environment. It is not intended nor approved for use in an industrial environment. Part Number: 07MSNBX-QS, Rev. B Sales Office: +1 (301) 975-1000 Technical Support: +1 (301) 975-1007 Revised: June 25, 2014 E-mail: support@patton.com Web: www.patton.com...
Page 2
• Do not open the device when the power cord is connected. For systems without a power switch and without an external power adapter, line voltages are present within the device WARNING when the power cord is connected. • For devices with an external power adapter, the power adapter shall be a listed Limited Power Source The mains outlet that is utilized to power the device shall be within 10 feet (3 meters) of the device, shall be easily accessible, and...
Page 3
1.0 Before you begin In the box, you will find: • One SmartNode Branch eXchange (SNBX) • One External Power Supply • One RJ45 Ethernet Straight Cable (male-to-male) • One warranty sheet • One packing slip • One SmartNode Branch eXchange Quick Start Guide To install the SNBX, you will need (not included): •...
Page 4
192.168.200.10/24 with a default route to 192.168.200.1. The default HOSTNAME is PATTON-SNBX in a workgroup labeled WORKGROUP. The Windows Administrator account is patton/patton 5.1 Connecting the Ethernet management interface Connect the supplied (or other) CAT5 Ethernet cable to the LAN port on the rear panel of the SNBX.
Page 5
SNBX models, along with warranty, trademark, and compliance infor- mation. • 3CX Systems Manual: www.3cx.com/manual/3CXPhoneSystemManual11.pdf Note Contact Patton Tech Support below for questions or concerns installing, configuring, or troubleshooting the Patton SmartNode Branch eXchange device. A.0 Customer and Technical Support Toll-Free VoIP support: call sip:support@patton.com...
Page 6
IEC/EN60950-1 2nd Edition B.2 CE Declaration of Conformity Patton Electronics, Inc declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2004/108/EC relating to elec- tromagnetic compatibility, Directive 2006/95/EC relating to electrical equipment designed for use within certain voltage limits and Directive 2011/65/EU relating to RoHS compliance.
Need help?
Do you have a question about the SmartNode Branch eXchange Series and is the answer not in the manual?
Questions and answers