Installation Instructions
4"
ASD-13
Fig. A
Place the plastic anchors in the holes. Drive
05
them in with a lite hammer.
Automatic Liquid Soap Dispenser
Package Includes
Soap Dispenser
Stainless Steel Construction
Dispenses Standard Liquid Soap Only, commonly found in retail stores
1000ml Integral / Soap Bottle
Vandal Key
Integral Battery Compartment
Mounting Hardware
Batteries Pre-installed
All hardware necessary for satisfactory installation
Tools Needed
Safety Glasses
Hammer
01
03
04
Drill Holes Ø 1/4"
Please cut for drilling holes
Align the holes of
06
the dispenser with
the holes of the
anchors. Insert
screws in and
fasten using a
Phillips screw
driver.
User Manual
Model: ASD-13
(6 AA)
Level
Cordless Drill
Phillips Screw Driver
02
Once the location for the Soap
dispenser has been decided,
proceed with the installation
steps below, if the soap
dispenser is installed above the
sink, leave a space of 18" from
the top of the sink to the
bottom of the soap dispenser as
shown below in figure (A).
1. Cut the template from the
back of the dispenser box.
2. Use a level to align the
template correctly.
3. Use painters tape to hold the
template in place.
4. Drill holes for supplied plastic
anchors.
Insert the key into the hole
07
located at the top of the
dispenser, push down with the
key and pull the cover open.
The cover engages a power
cut-off switch located in the
dispenser. The dispenser will
not activate when the cover is
in the open position.
Drill bit
Ø 1/4" Carbide
Drill for tile
Tape
PAGE | 01