Vacuum 12 gallon, floor sanding dust control vacuum (24 pages)
Summary of Contents for Clarke CAV 26
Page 1
This book has important information for the use and safe operation of this machine. Failure to read this book prior to operating or attempting any service or maintenance procedure to your Clarke American Sanders machine could result in injury to you or to other personnel; damage to the machine or to other property could occur as well.
Suction Unit Assembly Drawing ... 14 Suction Unit Assembly Parts List ... 15 Filter Group Assembly Drawing and Parts List ... 16 Control Panel Assembly Drawing and Parts List ... 17 Electrical Schematic ... 18 Page Clarke ® American Sanders Operator's Manual - CAV 26...
- Use extra care when cleaning on stairs. - Connect to properly grounded outlet. See “grounding Instructions”. - Do not use unless all filtering elements are present. Clean filtering elements frequently. SAVE THESE INSTRUCTIONS. ® Clarke American Sanders Operator's Manual - CAV 26 Page...
INTRODUCTION AND INSTRUCTIONS The CAV 26 comes fully assembled. It is specifically designed for dry pick-up of fine dust made from grindings of wood or gypsum. It is mounted on tough rubber wheels, two of which swivel in order to make the machine easy to handle. It also has brakes to safely stop the machine in place.
Page 5
Figure 4, 3 - Electrical Label Figure 4, 4 - Illuminated Mains Voltage Indicator When on, this indicates that the vacuum is connected to the electrical supply. Figure 4 ® Page Clarke American Sanders Operator's Manual - CAV 26...
12 AWG or greater than 50' in length will overheat and potentially cause a fire. 2. Connect the CAV 26 to a wall outlet matching one of the two shown in figure 5. No adaptor should be used with this appliance.
Page 7
This allows the canister to lift until it fits against the filtering chamber. ® Clarke American Sanders Operator's Manual - CAV 26 Figure 7 Figure 8 Figure 9 Page...
2. Replace it with another with suitable characteristics. 1. Remove and replace the carbon brushes. 1. Check all ground connections. Especially check the suction inlet fitting. Lastly, the hose must be strictly antistatic. Clarke ® American Sanders Action Operator's Manual - CAV 26...
Page 19
2100 Highway 265 Springdale, Arkansas 72764 (479) 750-1000 Technical Service 1-800-356-7274 ® Clarke American Sanders Operator's Manual - CAV 26 European Locations PRODUCTION FACILITIES ALTO Danmark A/S, Aalborg Blytaekkervej 2 DK-9000 Aalborg +45 72 18 21 00 ALTO Danmark A/S, Hadsund...
Page 20
(b). Return the product to the nearest Clarke American Sanders repair location. Transportation charges to and from the repair location must be prepaid by the purchaser. (c). Clarke American Sanders will repair the product and or replace any defective parts without charge within a reasonable time after receipt of the product.
Need help?
Do you have a question about the CAV 26 and is the answer not in the manual?
Questions and answers