Setting Up The Tripod - Lifepro BioLux User Manual

TESTING FOR SKIN SENSITIVITY
Before your first treatment, it is important to perform a skin sensitivity
test to ensure you won't experience any adverse reactions to light therapy.
To do a sensitivity test:
1. Hold the BioLux against your inner arm, with the LEDs against your
skin.
2. Press and hold the On/Off button for 2 seconds to turn on the BioLux.
3. Press the Time button once to increase the treatment time to
10-minutes
4. Tap the On/Off button to begin the treatment program. Allow the entire
treatment program to run.
5. If your skin feels uncomfortable or hot at any point during the test
treatment, stop using the BioLux immediately.
6. Wait at least 6 hours after the sensitivity test. If your skin becomes
red and/or itchy, you may be sensitive light therapy and you should not
continue to use the BioLux.
CONTRAINDICATIONS
• Do not use this product if you are, suspect you may be, or are planning to
become pregnant, or if you are, or plan to begin, breastfeeding.
• Do not use this product if you have cancer or suspect you may have
cancerous lesions.
• Consult your physician before using this product if you:
• Take steroid medication or receive steroid injections, if you recently had
surgery, skin filler injections, or if you have a tattoo in the treatment
area.
• Have a condition that may make you sensitive to light or sunlight, such
as Lupus, some forms of eczema, light-induced migraines, albinism,
rosacea.
• Take medication that makes you sensitive to sunlight, including some
antibiotics, chemotherapy drugs, and diuretics.
• Use products that may cause photosensitivity, such as citrus essential
oils, St. John's Wart, antibacterial soap, coal tar and petroleum
products.
8 BioLux User Manual Lifepro

SETTING UP THE TRIPOD

SET UP THE TRIPOD
The BioLux may be used hands-free by mounting it to the included tripod. To
set up the tripod (see the tripod parts of diagram on page 7):
1. Unfold the tripod legs.
a. Loosen the screw at the top of each leg with a Phillips head
screwdriver (not included).
b. Loosen the knob at the top of the base.
c. Adjust the legs to the desired position.
d. Ensure the tripod is stable and level, then tighten the screws.
2. Screw the clamp onto the base.
a. Push the telescoping post up to expose the threads at the top.
Tighten the knob to hold the telescoping post in place.
b. Screw the tripod clamp to the threads at the top of the base.
3. Adjust the height of the tripod by loosening the knob and sliding the post
up or down. Tighten the knob once the post is at the desired height (the
range is 7.4"–10.2").
USE THE TRIPOD WITH THE BIOLUX
1. Squeeze the clamp with one hand to open it as you position the BioLux in
the jaws of the clamp.
a. Ensure the BioLux diodes are pointing towards where you will be
seated.
2. Set the tripod on a level surface such as a table, a night stand, or the
floor.
3. The tripod tilts 180° at the hinge just below the clamp. Firmly grasp the
device and clamp and tilt it forward or backward.
4. You may adjust the height of the device by sliding it up and down within
the clamp or by using the knob and post as described in Set Up Step 3.
5. Power on the BioLux and enjoy your hands-free treatment session.
6. To release the BioLux from the tripod, hold the device in one hand and
squeeze the clamp with your other hand.
NOTE: To fold the tripod for transport or storage, complete Set Up Steps 1–3
in reverse.
Wellness Recovery Collection 9