Safety Considerations; General; Before Switching The Unit; Avoid Electrocution - Daikin EWWQ-KC Operating Manual

1.

SAFETY CONSIDERATIONS

1.1.

General

Installation, start-up and servicing of equipment can be hazardous if certain factors particular to the installation are not considered:
operating pressures, presence of electrical components and voltages and the installation site (elevated plinths and built-up up
structures). Only properly qualified installation engineers and highly qualified installers and technicians, fully trained for the
product, are authorized to install and start-up the equipment safely.
During all servicing operations, all instructions and recommendations, which appear in the installation and service instructions for
the product, as well as on tags and labels fixed to the equipment and components and accompanying parts supplied separately,
must be read, understood and followed.
Apply all standard safety codes and practices.
Wear safety glasses and gloves.
WARNING The emergency stop causes all motors to stop, but does not switch off power to the unit.
Do not service or operate on the unit without having switched off the main switch.
1.2.

Before switching the unit

Before switching on the unit read the following recommendations:
•
When all the operations and all the settings have been carried out, close all the switchbox panels
•
The switchbox panels can only be opened by trained personnel
•
When the UC requires to be accessed frequently the installation of a remote interface is strongly recommended
•
LCD display of the unit controller may be damaged by extremely low temperatures (see chapter 2.3). For this reason, it
is strongly recommended to never power off the unit during winter, especially in cold climates.
1.3.

Avoid electrocution

Only personnel qualified in accordance with IEC (International Electrotechnical Commission) recommendations may be permitted
access to electrical components. It is particularly recommended that all sources of electricity to the unit be shut off before any
work is begun. Shut off main power supply at the main circuit breaker or isolator.
IMPORTANT: This equipment uses and emits electromagnetic signals. Tests have shown that the equipment conforms
to all applicable codes with respect to electromagnetic compatibility.
WARNING Direct intervention on the power supply can cause electrocution, burns or even death. This
action must be performed only by trained persons.
WARNING RISK OF ELECTROCUTION: Even when the main circuit breaker or isolator is switched off,
certain circuits may still be energized, since they may be connected to a separate power source.
WARNING RISK OF BURNS: Electrical currents cause components to get hot either temporarily or
permanently. Handle power cable, electrical cables and conduits, terminal box covers and motor frames
with great care.
WARNING In accordance with the operating conditions the fans can be cleaned periodically. A fan can start
at any time, even if the unit has been shut down.
D-EOMHP01501-22_00EN 3/29