Exhaust Connection - GE DSKS433EBWW Installation Instructions

EXHAUST INFORMATION
WARNING -
UNITED STATES, THE REQUIRED EXHAUST DUCT
DIAMETER IS 4 in (102mm). DO NOT USE DUCT LONGER
THAN SPECIFIED IN THE EXHAUST LENGTH TABLE.
WARNING -
BEFORE PERFORMING THIS
EXHAUST INSTALLATION, BE SURE TO DISCONNECT
THE DRYER FROM ITS ELECTRICAL SUPPLY.
The correct exhaust installation is YOUR RESPONSIBILITY. Problems
due to incorrect installation are not covered by the warranty.
MAXIMUM ALLOWABLE
EXHAUST SYSTEM CHECK LIST
HOOD OR WALL CAP
SEPARATION OF TURNS
TURNS OTHER THAN 90º
IF YOUR DRYER COMES WITH REAR EXHAUST,
TO CHANGE TO SIDE OR BOTTOM EXHAUST:
FOR SIDE EXHAUST:
FOR BOTTOM EXHAUST:
IN CANADA AND IN THE
ALTERNATE EXHAUST INSTRUCTIONS
295 mm
115 mm
EXTENSION DUCT
It is importat to replace the ground clip after
cutting the exhaust duct, (on rear exhaust model)
SEALING OF JOINTS
INSULATION

EXHAUST CONNECTION

WARNING -
OF FIRE OR PERSONAL INJURY:
IF YOUR DRYER COMES WITH TOP EXHAUST,
DRYER TOP VIEW
152 mm
TO CHANGE TO SIDE OR REAR EXHAUST:
6"
Left knockout
203 mm
Blower
(8")
Bottom
knockout
FOR SIDE EXHAUST:
Right knockout
89 mm
(3½")
(11½")
For Rear Exhaust
(4½")
For Side Exhaust
Rigid
Metallic
Ducting
Cut Here
FOR REAR EXHAUST:
TO REDUCE THE RISK