Related Manuals for X-media XM-EN2279
Summary of Contents for X-media XM-EN2279
- Page 1 User Guide USB SATA HDD/SSD External Enclosure Model No.: XM-EN2279 XM-EN2279U3 Version 1.0...
-
Page 2: Table Of Contents
USB SATA HDD/SSD External Enclosure Contents Package Contents ......................3 Chapter 1 Product Overview …….………………….….……………………….………………………… 3 1.1 Introduction ……………………….…………………………………….………………….. 3 1.2 Features …….………………….….…..……………………………………………………… 4 1.3 System Requirement ………………...……………………………….…………………. 4 Chapter 2 Installation Guide ………………..…………………………………………..………………….. 4 2.1 Hardware Installation …………….………..……….……………………..………….. 4 2.2 Driver Installation ………….………………..…………………….…………..…………... -
Page 3: Package Contents
Conventions The “Enclosure” mentioned in this User Guide stands for following products: XM-EN2279 or XM-EN2279U3 without any explanations. All these devices are sharing this User Guide. All product models listed just differ in appearance and figure in this User Guide. -
Page 4: Features
USB SATA HDD/SSD External Enclosure 1.2 Features Support most 2.5” 7mm/9.5mm SATA HDD/SSD USB 2.0 data transfer rate up to 480Mbps (Model: XM-EN2279) USB 3.0 data transfer rate up to 5Gbps (Model: XM-EN2279U3) Tool Free case design for easy installation ... - Page 5 USB SATA HDD/SSD External Enclosure Figure 2 Place your 2.5” SATA hard disk into the Enclosure and then slide it into SATA connector. Closing the top panel will push in the hard disk to have tight contact with SATA connector of PC Board. Figure 3 Note: If you are installing 2.5”...
-
Page 6: Driver Installation
USB SATA HDD/SSD External Enclosure Figure 5 Connect the USB cable from the Enclosure to the computer system. 2.2 Driver Installation No driver installation is required for USB enabled computer systems, as this enclosure uses natively installed driver. Supported operating systems should automatically detect and install the enclosure. -
Page 7: Using The Enclosure
USB SATA HDD/SSD External Enclosure 2.4 Using the Enclosure If you are using a brand new hard disk that doesn’t contain any data, then you will first need to prepare the hard disk for use. From the main desktop, right-click on “Computer”, then select Manage. In the new Computer Management window, select Disk Management from the left window panel.