High Temperature Alarm; Cleaning And Maintenance - TaoTronics TT-AH018 User Manual

High Temperature Alarm

High temperature alarm will be activated if temperature of the heat tube is too high, 8
beep sounds will be heard every other second. The unit will stop working after 1
minute.
Caution: Unplug the power source and wait for 3 minutes to allow the unit to
cool down before you turn it on again.
Installing the Floater
1. Align and insert the 2. Match the large
small notch notch on the other side
Removing the Floater
1. Pull out the small
plug f irst
3. Push in the large plug
to secure in place
2. Withdraw the large notch to
remove the oater

Cleaning and Maintenance

Make sure to turn off the unit and unplug it from the power source before cleaning.
1. Remove the tank from the base and drain water.
2. Fill the tank half full and add 100ml 5% white vinegar. Run the humidi er for 5-10
minutes to allow the mixture to work through and loosen up the gunk.
3. Use the included cleaning brush for better cleaning.
4. Be careful when you drain water to avoid water getting into the underside or motor
area and damage the product.
5. Use a soft cloth to wipe the outside of the unit to remove any ngerprints, smudges,
etc.. The cloth can be damped with water, or dipped with a bit of gentle cleaner or
vinegar / water solution.
6. Clean the humidi er once a week.
05/06