AEG 40809 User Instructions page 22

User's instructions
3. Adding detergents
If necessary, pour the softener into the softener distributor ( ).
Your washing machine was designed to reduce consumption of water and
detergents. Therefore make sure that the levels in the product box (deter-
gent, softener) are below the MAX marks at the side of your product box
display port.
4. Press the necessary buttons if you wish.
5. Choosing the temperature
Choose a temperature that is appropriate for the program that you have
chosen, with reference to the information given on the programs table.
6. Choosing the spinning speed
Choose the spinning speed which corresponds to the chosen programme
according to the nature of the laundry and the degree of humidity wished
at the end of the cycle.
7. Choosing the program
Choose a program depending on the nature and dirtiness of your washing.
Turn the programmer handle in the clockwise direction until you find your
chosen program.
8. Starting the program
Check to make sure that the water tap is open.
You can use the On/Off pushbutton to start your washing machine. The light
comes on and the program starts, when you press on this button.
9. When the program is finished
The washing machine stops automatically and the programmer stops on a
stop position.
Programs finish with:
a spin (for all programs) if you did not select the RINSE HOLD button.
a stop with the tub full of water (for all programs) if you selected the
RINSE HOLD button. You can then finish these programs either with
a spin by releasing the RINSE HOLD button, or by draining by putting
the timer on the DRAIN program, but do not forget to release the
On/Off button before making your selection.
22