Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Bush Power G2000i
Summary of Contents for Bush Power G2000i
- Page 1 G2000i INVERTER GENERATOR...
- Page 2 Preface Congratulations on purchasing a Bushpower G2000i Inverter Generator. Before using your G2000i it is important to have a full understanding of it’s operation and safety devices. Please take time to read this manual. Please pay careful attention to any direction or comment with the following labels;...
-
Page 3: Table Of Contents
Contents Item Page Number Safety Parts Identification Before starting Starting the generator Operation Alarms Shutting down Maintenance Transport / Storage Trouble shooting Specifications Warranty Statement... -
Page 4: Safety
SAFETY To ensure safe operation always follow the instruction manual. Read instruction manual carefully BEFORE operating the generator. Failure to do so could result in injury, death or damage to the generator. When operating the generator ensure there is adequate ventilation. Failure to do so could result in injury or death. -
Page 5: Parts Identification
PARTS INDENTIFICATION Filler cap and vent switch Engine start and run switch Control Panel Maintenance cover Starting pull handle Engine ON OFF switch Spark plug cover Engine exhaust... - Page 6 PARTS INDENTIFICATION Economy switch Output indicator Overload indicator Low oil indicator 240Volt AC outlets DC outlet and reset switch LCD Display: Output Volts Output Hertz KW output Total Hours...
-
Page 7: Before Starting
BEFORE STARTING Fill Oil Ensure generator is on a flat surface and a minimum of one meter from any building or obstruction Always use a high grade engine oil suited to the environment the generator is being used. Most common oil is a high grade 10W40. Oil must be added to the generator before first operation. - Page 8 BEFORE STARTING Fill Petrol (E10 not suitable) Always use ULP petrol, use of leaded or E10 petrol will damage the generator and void warranty Remove fuel cap, fill with ULP to required level. The generator has a capacity of 3.7L. If spillage or overflow of petrol ensure all petrol is washed away before starting the generator.
- Page 9 BEFORE STARTING Check Air Filter After continued use the air filter will become clogged with dust and other particle. To ensure smooth operation of the generator it is recommended that you check the air filter on a regular basis depending on the environment the generator is being used. Do not run the generator without the air filter in place.
-
Page 10: Starting The Generator
STARTING THE GENERATOR Before starting the generator ensure there is no appliance connected to either the 240Volt AC outlets or the DC outlet. Turn vent valve on fuel filler cap to “on” position. On and Off indicator Turn the engine switch to the “on” position. Engine on / off switch Turn engine run / start switch to “start”... -
Page 11: Operation
OPERATION In order to prevent electric shock the engine should be suitably earthed from the earth port on the control panel. Earth point • Do not exceed rated power of generator. • Do not exceed amperage of 240Volt AC outlet. •... - Page 12 OPERATION DC output is to be used for charging sealed lead acid batteries only. The DC output is not designed to be used as a DC power source. Connect charging cable to generator (ensure generator is “on”). Connect charging clamps to battery by connecting red (positive) first the black (negative) second. Plug charging cable into generator To disconnect charging unplug charge cable Disconnect charging clamps...
-
Page 13: Alarms
ALARMS • Low Oil Alarm • The generator is equipped with a low oil alarm system. • When the generator detects a low level of oil the ‘low oil” indictor light will illuminate. • Continued use of the generator with low oil can damage the unit and may void warranty. -
Page 14: Maintenance
MAINTENANCE Ensure the generator is OFF and cool before carrying out any maintenance. Item / period Each use 1 month or 3 months 6 months 12 months 20 hours or 50 or 100 or 200 hours hours hours check ▲ change ▲... - Page 15 MAINTENANCE Spark Plug maintenance Remove spark plug cover on top of generator. Gently remove spark plug cover and wire. With supplied tool remove spark plug. Check spark plug for crazing around white insulation. If this has occurred you will need to replace the spark plug.
-
Page 16: Transport / Storage
TRANSPORT / STORAGE To avoid petrol leaking from the generator during transport or temporary storage ensure that the unit is upright and the vent switch on the petrol cap is in the “off” position. If transporting the generator in the cabin of the vehicle ensure there is adequate ventilation. Do not expose generator to direct sunlight for long periods of time if transporting in the cabin of the vehicle. -
Page 17: Trouble Shooting
TROUBLE SHOOTING Engine will not start: Fill with fuel Fuel in tank? Is the engine start switch in the ON Switch ON position? Is there enough oil in the Fill oil generator? Check spark Replace spark plug for spark plug Contact Bushpower... - Page 18 TROUBLE SHOOTING Engine will not start: Does the output indicator light illuminate? Check fuel Does the overload indicator light Disconnect all appliances illuminate? Does the low oil Fill with oil indicator light illuminate? Contact Bushpower...
-
Page 19: Specifications
TECHNICAL SPECIFICATIONS MODEL G2000i Length * width * height 555 * 305 * 460mm Net weight (kg) 26.5kg Engine type 4 stroke, overhead air valve, one cylinder Compression 8.8:1 4300 Cooling Direct induction Ignition Transistor Oil Capacity 0.4L Fuel Capacity 3.7L... -
Page 20: Warranty Statement
Warranty Card Name: Company Name: Address: Fax: E-mail: Purchased From: Date Purchased: Product Purchased: (Model No.) Return Authority Number: Please Note: Proof of purchase will be required for all warranty claims. **Refer to the full warranty statement at www.bushpower.com.au *** This product is covered by a 12 month warranty Bushpower Pty Ltd 100 Links Road StMary’s NSW 2760...