4. Feed the sensor wires through the opening of the GarageSmart
connect to the SENSOR + and SENSOR - pins of the 10-Pin terminal block (polarity
doesn't matter), using a screw driver.
Sensor Wires
24V +
24V –
SENSOR +
SENSOR –
OPEN
CLOSE
STOP
COM
AUX NO
AUX COM
AUX NC
5. Feed the OPEN, CLOSE, STOP and COM wires through the opening of the
™
GarageSmart
device and then connect to the 10-Pin terminal block using a screw
driver, as shown below.
24V +
24V –
SENSOR +
SENSOR –
OPEN
CLOSE
STOP
COM
AUX NO
AUX COM
AUX NC
User's Manual
TM
GarageSmart
™
device and then
Note:
Using ¾" Conduit and a Lock Washer
(shown above) is a typical application
in securing and sealing the wires
entering the GarageSmart device.
Wires connect to the OPEN, CLOSE,
STOP and COM terminals of the garage
door motor control board.
See the
wiring diagram
at the beginning of
this section for further information on how
to connect these connections.
17