Lifetech mibody Quick Start Manual

mibody
QUICK START GUIDE
Getting started
Remove the mibody device
from the packaging

Turning ON

Press Power button to
turn ON the mibody.
LED will be steady.

Charging

Plug the USB charging cable into the
charging port of the device.

Attaching the pads

Attach the adhesive electrode pads to
the press stud connectors on the back
of the mibody device (x2)

Selecting Treatment mode (1-6)

mibody by default will start on mode 1.
Press, hold (+) button and release
after 2 beeps for mode 2.
then, press, hold (+) button and
release after 3 beeps for mode 3.
The number of audible beeps
correspond to the desired treatment
programme. Repeat the same steps
for modes 4, 5 and 6.

Charging indications

Connect the charging cable to a
USB charging source.
LED flashing = charging
LED steady = fully charged

Placement of the pads

Remove the plastic protectors from
the electrode pads and place pads
onto the skin, spanning the desired
treatment area. Pads should be
placed at least 6cm apart, either
side of the affected area.

Adjusting the intensity

Press (and release) (+) or (-) to
increase or decrease the intensity
until you reach the desired level.
mibody has 10 intensity levels.
Intensity defaults to zero at the
start of each treatment.