Table of Contents
Advertisement
Connecting the VCR to a Decoder/
Connecting the VCR to a Stereo Amplifier
To connect this VCR to a decoder or a stereo amplifier, make
the connections shown in the illustration below.
For the connection to the TV, see page 7.
.
For details about the connection, also read the operating
instructions of the decoder or stereo amplifier.
Be sure to keep the VCR, TV and decoder or stereo amplifier
switched off until you have finished all connections.
For your safety, do not connect or handle the equipment with
wet hands.
To Connect the VCR to a Decoder
Decoder here refers to the device used to decode scrambled
broadcasts (Pay TV).
Decoder (not supplied)
2
To an AC mains socket
1
Connect a 21-pin Scart cable (not supplied) to the AV2
21-pin Scart socket a on the VCR and to the 21-pin
Scart socket on the decoder.
2
Connect the decoder's mains lead to an AC mains
socket.
3
Set "AV2" to "DECODER".
For details, see page 27.
AV Link Function
If the VCR is connected to the TV via a 21-pin Scart cable,
you can use AV LINK button A to switch the TV from normal
TV reception over to the video playback channel (AV input)
(and vice versa). In the VCR mode (when the VCR indication
in the VCR display is lit), the TV is switched to the video
playback channel (AV input). In the TV mode (when the VCR
indication is not lit), the TV is switched to TV reception.
VCR
VCR Mode
VCR indication
is lit.
TV Mode
VCR indication
is not lit.
≥ When you press the MENU button S to display the menu
on the TV screen, the TV is also automatically switched to
the VCR mode, however, the VCR indication does not
appear in this case.
a
1
21-pin Scart socket
21-pin Scart cable
(not supplied)
TV
AV Input
is selected.
TV reception
is selected.
≥ When you start playback on the VCR, the TV is
automatically switched to the VCR mode. However, during
playback, it is not possible to switch the TV back to the TV
mode.
≥ If a Pay TV station has been selected on the VCR when
you switch to the TV mode, the picture on the TV is
scrambled when you select a Pay TV station on the TV. In
this case, either switch to the VCR mode or select the AV
input on the TV.
Hint:
"RGB" means separate Red/Green/Blue colour signals. If
you connect a TV equipped with RGB input capability to the
AV1 socket ` on this VCR, and a decoder equipped with
RGB output capability to the AV2 socket a, the TV can
receive RGB signal input from the decoder via the VCR.
To Connect the VCR to a Stereo Amplifier
Audio cable
(not supplied)
2
To an AC mains socket
1
Connect an Audio cable (not supplied) to the Audio
Output sockets b on the VCR and to Audio Input
sockets on the stereo amplifier.
2
Connect the stereo amplifier's mains lead to an AC
mains socket.
1
b
Audio Input sockets
Stereo amplifier (not supplied)
19
Advertisement
Table of Contents
