Emergency Operation; Emergency Stopping - Prism CP User Manual

To charge the hoist, you must first open the small blue bung at the base of the handset to open the charging port. Then you
must place the handset into the charging dock as shown in the figures below. The handset front face will be facing towards the
wall with the attachment hook facing away. Slide the handset all the way into the dock and carefully push until the dock has
attached to the handset port.
To ensure the Hoist is charging, check the LED's on the Cover are showing, charging or charged.
Figure 36
Use only the charger that was supplied with the hoist or provided as a replacement. Use of any other charger will void all
warranties and may cause damage to the hoist.
When Charging has completed, ensure that the Blue rubber bung at the base of the handset is inserted back into
the charging port. This ensures that the stated IP compliance of the handset is maintained.

6.6 Emergency Operation

Emergency stopping

The Hoist unit has an emergency shut-off feature that allows the operator to cut all power from the Hoist.
By pulling the power cord hanging down from the bottom cover of the Hoist, all powered functions of the Hoist will cease
immediately. (Figure 40)
Once the Emergency Stop has been used, the Hoist unit will need to be reset in order to operate again. Contact your local
authorised dealer to reset the Hoist – contact details are on the last page of this manual.
Once reset, simply press any button on the handset to resume power.
Figure 40
999016 – Revision G
Figure 37
Figure 38
Figure 39
P a g e | 26 of 44