Advertisement
Other Useful Information
Troubleshooting
If the foot spa is not working, please check that the power plug is properly
connected, then turn the control knob to mode 3. If the LED light still does not turn
on and no bubbles are generated, please contact our after sales support.
Cleaning and care
• Before cleaning the product, make sure it is disconnected from power source.
• Clean the water container only with a soft, slightly damp sponge or cloth. Do not
use detergents or cleaning agents for cleaning. Dry thoroughly using a dry cloth.
• Do not immerse the product in water.
• If bath salts and/or herbals were used in the session, clean up straight after use.
Storage
• Unplug the product from the power source and allow it to cool down and dry.
• Store the product in the original box to keep dust accumulation to a minimum.
• Do not store the product close to a fireplace or other heating sources.
Service and repair
• The product contains no user-serviceable parts. Do not attempt to take it
apart, repair or modify it.
• Do not operate the product if it is damaged or working abnormally. Contact
our after sales support centre if a service is required.
Compliance
This appliance has been fully tested and meets all requirements as set out by
standards AS/NZS 60335.2.32 for electrical safety.
The RCM Mark (Regulatory Compliance Mark) indicates that the product
complies with the relevant guidelines of the ACMA as well as corresponding
government requirements for the safety of electrical devices.
E209
9 9
Advertisement
