Advertisement
Operation
Power on
• Connect the spa to a power source.
1
2
Using the device
• Fill the spa with water.
• Once filled, place the spa on a flat and dry surface.
• Sit down and place your feet into the container.
• Turn the control knob to the desired mode.
• Slide your feet back and forth over the feet massagers.
• NOTE: it is recommended to not use the product for longer than 60 minutes.
• Turn the control knob to mode 0 to turn the spa off.
• After use, tip the water out by the following steps:
1. Make sure the spa is turned off.
2. Unplug the power adaptor from the power source.
3. Tip the spa at an angle, allowing water to pour out.
ATTENTION: Never turn on power nor operate the spa
without water in the container.
ATTENTION: Never use the spa while standing up.
8 8
3
4
1. Mode 3: Bubble mode + LED light mode
2. Mode 0: Turn off
3. Mode 2: LED light mode + keep water warm
4. Mode 1: Bubble mode + keep water warm
Advertisement
