Module Identiþcation; P1 To P3 - Link Channel Connectors - Kongsberg RSER200-4 Hardware Description

4.1 Module identiÞcation

4.2 P1 to P3 - Link Channel connectors

300993/Ap27
There is a module identiÞcation label on each module. For any
communication with Kongsberg Maritime on this module you
should refer to the part number (Part#), revision (Rev.) and serial
number (Serial#). The information is also available from the
system.
Figure 11 Module identiÞcation label
These connectors are RJ45, 8 pin, unshielded.
The Link Channel connection to RCU has to use a straight (not
crossed) cable with all 8 pins in use.
Figure 12 Front view of RJ45 with pin layout
1
8
(Vs090019a)
Table 3 Link Channel connectors (RJ45) pin allocation
Pin no. Name
1 RXn-P
RXn-N
2
3 TXn-P
4 CTSn-P
5 CTSn-N
6 TXn-N
7
8
where n = 1 for P1, 2 for P2, 3 for P3
Function
Link Channel #n Receive, Positive terminal
Link Channel #n Receive, Negative terminal
Link Channel #n Transmit, Positive terminal
Link Channel #n Clear To Send, Positive
terminal, Input
Link Channel #n Clear To Send, Negative
terminal, Input
Link Channel #n Transmit, Negative terminal
Not connected
0 V 0 V, signal reference terminal
ConÞguration
15