Warnings - Neslab RTE-Series Manual

Warnings

Make sure you read and understand all instructions and safety precautions
listed in this manual before installing or operating your unit. If you have any
questions concerning the operation of your unit or the information in this
manual, contact our Sales Department.
Performance of installation, operation, or maintenance procedures
other than those described in this manual may result in a hazardous
situation and may void the manufacturer's warranty.
Transport the unit with care. Sudden jolts or drops can damage the
refrigeration lines. The units weigh approximately: RTE-111, 86 pounds
(390 kilograms); RTE-211, 99 pounds (45 kilograms); RTE-221, 106
pounds (48 kilograms). Units should be transported with equipment
designed to lift these weights.
Observe all warning labels.
Never remove warning labels.
Never operate damaged or leaking equipment.
Never operate the unit without bath fluid in the bath.
Never use pure ethylene glycol as a bath fluid. Above 80°C the user is
responsible for the fluid used.
For 220 - 240 volt units supplied without a line cord, use a harmonized
(HAR) grounded 3-conductor cord, type H 0 5 V V - F , with conductors
listed below. A suitable cord end is required for connecting to the
equipment (see unit socket) and must terminate with an IEC approved
plug for proper connection to power supply.
RTE-111 and RTE-211
RTE-221
Always turn off the unit and disconnect the line cord from the power
source before performing any service or maintenance procedures, or
before moving the unit.
Always empty the bath before moving the unit.
Never operate equipment with damaged line cords.
Refer service and repairs to a qualified technician.
In addition to the safety warnings listed above, warnings are posted
throughout the manual. These warnings are designated by an exclamation
mark inside an equilateral triangle with text highlighted in bold print. Read and
follow these important instructions. Failure to observe these instructions can
result in permanent damage to the unit, significant property damage, personal
injury or death.
Section I Safety
Nominal 1.0 mm
Unit Socket: IEC - 320 C13
Nominal 1.5 mm
Unit Socket: IEC - 320 C19
- 3 -
2 cross section rated 10 Amps
2 cross section rated 16 Amps