Advertisement
• To prevent an overflow condition:
– Do not begin a mix before the Low-Level Indicator illuminates.
– If changing from one type of chemical to another (RA/RP developer and fixer, RP LO Fixer), contact a
qualified service provider to change the Specific Gravity Floats and the Templates.
When a Low-Level Indicator illuminates and you hear the audible alarm, do the following steps to begin the mixing
process:
[1] Open the DEVELOPER or FIXER DRAWER.
[2] Remove the cap from the Standard Bottle(s) of developer or fixer replenishment concentrate.
Important
• Do not remove the foil seal that covers the opening of the Bottle(s).
• The chemicals made by Kodak for use in the AUTOMIXER are packaged in recyclable plastic Bottles. Look for
the mark on the bottom of the Bottles for correct disposal.
• The RA developer concentrate made by Kodak makes a 9.5 L (2
use 2 Bottles. The other replenishment concentrates made by Kodak make 19 L (5 gal) mixes; only one Bottle
of concentrate is required.
[3] To pierce the seal, push the Bottle(s) down firmly onto the Knife(s) in the Developer or Fixer Template.
[4] Check that each Bottle is draining. If not, push down more firmly on the Bottle(s) to pierce the seal. The
AUTOMIXER will automatically add the water for the correct chemical mix.
[5] When a Bottle is empty, remove the Bottle.
[6] Correctly dispose of the Bottle.
[7] Close the Drawer.
[8] Observe the 3 Solution-Level Indicators on the Front Panel to verify that the Replenishment Tank has been
filled.
9B8815 – January 1997
FIXER
DRAWER
DEVELOPER
DRAWER
TEMPLATE
BOTTLE
⁄
1
gal) mix. To fill the AUTOMIXER to capacity,
2
Operating the AUTOMIXER
KNIFE
H115_0004BCA
H115_0004BA
5
Advertisement
