Advertisement
(Fig.11)
tape
Fig.11
8
9.
the
(Fig.12)
Fig.12
Glass
●Glass should be cleaned every week in order to keep
the shiny
Grease filter
●
The grease filter should be cleaned frequently (
every two months of operation, or more frequently for
heavy use). Use a warm detergent solution.
●
Grease filter is washable
●
Lift the glass to the height where the poles hold it.
●
Remove the grease filter by pulling out each latch
while the glass is open. This will disengage the filter
from the hood. Tilt the filter downward and remove.
●
Wash the filters, taking care not to bend them.
Allow them to be dry before refitting
●
When refitting the filters, make sure that the handle
is visible from the outside.
●
To install the grease filter, align rear filter tabs with
slots in the hood. Pull out the latch, push filter into
position and release. Make sure the filter is securely
engaged after assembly.
●
Push the glass to the original position.
Note: To replace the filter, please let the hood on
suction mode before cutting off the electrical supplier
and don't open the glass panel by hand.
Replacing the lamp
Replace the damaged LED, only use LED DC 12V,2X2W
Max
Note:
We recommend only using lamps of the same
specification as the ones being replaced.
WARNING: .
1. Always switch off the electrical supply before carrying
out any operation on the appliance.
2. Only a qualified and trained service technician can
undertake the work of bulbs replacement and servicing.
Changing the lamp
9
Advertisement
