Product Description - Strong 462117 Manual

STRONG electric lifting socket
Model: 462117, 462118, 462119, 462120

Product description:

Glass control panel with wireless
charging function
2 x USB interface
3 x French/Schuko stan-
dard output module
Ø 65mm
Fixing ring
Power cable
Important notice: IP44 rating (protection against water splashing from all di-
rections) is applicable in closed state only. Do not install close to sinks and ba-
sins, to avoid a possible leak of water inside the product. It is not meant for out-
door use.
WEEE – Waste Electrical and Electronic Equipment
These products must be recycled properly and should not be disposed as house-
hold waste. Incorrect disposal may cause environmental damage
Instructions:
• This product is meant for use as extension connection for power supply, to be
embedded into furniture.
•
Place the product in a round hole drilled with 65mm in diameter and fasten it
using the fixing ring. Then plug the cable into socket.
•
Activate opening/closing by double tapping the lighting mark on the top glass
panel. One short tap can be used to stop the motion.
•
Wireless charging is activated by placing the mobile phone on the glass panel.
Do not put there any items except smartphones with wireless charging sup-
port, otherwise this function would keep turning on and off.
• This product is equipped with anti-collision protection, which stops the mo-
tion of the upper part, if it´s blocked. This applies to both ways, up and down.
Caution:
•
CE marking together with Declaration of Conformity confirm compliance with
valid EU directives.
•
Restrictions and recommendations listed below fully comply to current safety
measures. Therefore, we recommend all the users to follow preventive safety
rules valid in their country during installation and maintenance of the device.
IP44
• The producer takes no responsibility for any possible damage caused by using
the product in a way which doesn´t comply to these instructions, mainly by in-
appropriate installation or by ignoring warnings.
•
The producer takes no responsibility for any malfunction, damage or destruc-
tion of the product caused by unprofessional change of parts, or by using non
original parts.
•
Do not disassemble or modify this device, otherwise the warranty will be void.
•
Unplug the device before every cleaning. Clean these products with a soft dry or
slightly moistened cloth. Avoid using scouring sponges, abrasive or aggressive
and/or corrosion causing cleaners.
• Children may use the device only under supervision of a responsible person.
• Do not lay the cable on rough or sharp surface or any places which could cause
damage.
.