Table of Contents
Advertisement
TROUBLESHOOTING
PROBLEM
Will not heat
(but vacuum comes on).
No solution from
spray nozzle tip.
Poor water pickup.
Overheats and
and boils water.
Plugged into outlet,
nothing comes on.
POSSIBLE CAUSE
Water level too low.
Nozzle tip plugged.
Check quick-disconnect fitting.
Solution tank empty.
Pump failed.
Kinked solution hose.
Vacuum hose cuff is not
firmly pushed onto
recovery tank fitting.
Vacuum motor intake
filter is clogged.
Vacuum gasket between tanks
is worn or damaged.
Recovery tank lid not sealing.
DEFECTIVE MACHINE!
DO NOT ATTEMPT TO REPAIR!
Left exposed in freezing conditions.
Defective pump seal.
Float level switch in solution tank
may be damaged.
Thermostat Failure.
Overloaded circuit breaker.
REMEDY
Fill water to top edge of lid ring.
Disassemble and clean.
Reconnect fitting onto machine.
Refill to absolute top of lid ring.
Replacement required.
Straighten hose.
Push hose cuff onto fitting.
Check for cracks in hose.
Remove and clean filter.
Replace gasket.
Replace or tighten lid.
Unplug immediately and call factory
Service Center or the point of purchase.
Refer to Service Center.
Replace pump.
Replace float switch.
Replace thermostat.
Circuit breaker reset.
Unplug other electrical items
on same circuit.
FORM S2-S2H200-1 AZTEC CARPET/HARD FLOOR EXTRACTOR (10-25-02) - 11
Advertisement
Table of Contents
