Advertisement
INSTALLATION STEPS
STEP 1
Remove your freestanding bath from the carton and place it in the
correct position for installation. Check for damage and ensure your
bath does not come in contact with any rough surfaces which may
scratch your bath. Place your freestanding bath on cardboard or
carpet during installation.
STEP 2
Turn the self-leveling feet so the bath base is level and 3 - 5mm
above the finished floor.
IMPORTANT
Installing the bath shell directly onto the bath floor will place
pressure on the outside wall of the bath and can crack the bath.
Ensure there is a gap of 3 - 5mm between the bath shell
and the floor.
Ensure the bath is level so all the water can drain to the
waste outlet.
STEP 3
Carefully tilt the bath on its side and connect it to the drain
outlet. We recommend using a flexible connector. Ensure
the flexible connector is cut to the correct length for easier
installation and to prevent drainage issues.
STEP 4
Before finishing, water test for leaks and correct drainage.
IMPORTANT
Fill the freestanding bath with water and check the water flows
easily to the waste outlet.
NOTE: A small amount of water may pool due to surface
tension.
STEP 5
Apply a thick bead of silicon around the bath base and the
finished floor and allow it to set for 24 hours before use.
WARRANTY TERMS & CONDITIONS - DOMESTIC USE
FREESTANDING BATH - Acrylic Shell / Steel Frame
Where a genuine manufacturing defect arises within the warranty period Oliveri will, at its election, repair the defect or replace the product
subject to the terms contained in the full warranty information available at https://oliveri.com.au/service-and-warranty.
This warranty does not cover against normal wear and will be voided if the product is misused or not installed in accordance
with these instructions.
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund
for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods
repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
SERVICE
If the product requires servicing, please contact your installer (preferably the one who installed it). If the plumber / installer is satisfied that
the problem is not due to poor installation, contact Oliveri's nominated Warranty Service Agent for assistance on:
Ph: (08) 8348 6444 (choose the after sales service and warranty option)
Email: warranty@oliveri.com.au
For full warranty information visit: https://oliveri.com.au/service-and-warranty
If a warranty service call finds that the product does not have a genuine manufacturing fault, our Warranty Service Agent
reserves the right to pass on any call-out fee to the householder.
Oliveri Solutions Pty Ltd. ABN 12 007 551 886
10 years replacement product, 1 year labour.
TF151a - Naples Freestanding Bath Installation Instructions
Waste
Flexible
Outlet
Connector
Drain
3 - 5mm
Page 2 of 2
Advertisement
