Asus ZenWiFi XT9 Quick Start Manual

Quick
Start Guide
ASUS ZenWiFi XT9
AX7800 Tri Band WiFi Router
Model: XT9
Before Setup
Preparing to set up an AiMesh WiFi system
Find two ZenWiFi XT9, and power both on.
1
Use a network cable to connect your optical modem to the WAN
2
port of either ZenWiFi XT9. This ZenWiFi XT9 will be the AiMesh
router, and the other ZenWiFi XT9 will be the AiMesh node.
The LED turns solid blue to indicate that ZenWiFi XT9 is ready for
3
setup.
ASUS Router App
Download free ASUS Router APP to set up and
manage your router(s).
AiMesh Setup Steps
01
Prepare
Place your AiMesh router and node within 3 me-
ters of each other during the setup process.
02 AiMesh node
Keep your AiMesh node powered on and stand-
by for AiMesh system settings.
03 Launching ASUS Router APP
Launch ASUS Router APP, and then follow the
on-screen instructions to finish the AiMesh set-
up.
Troubleshooting
If your AiMesh router cannot find any AiMesh node nearby or synchronization fails, please check the following
and try again.
Move your AiMesh node closer to the AiMesh router ideally. Ensure that it is within 3 meters.
a
Your AiMesh node is powered on.
b
Hardware Explanations
Plug the adapter into the DCIN port, and press the power switch.
1
The power LED will light up when your hardware is ready.
2
ZenWiFi XT9 Overview
DCIN port Power switch LAN ports 1-3
Specifications:
DC Power adapter DC Output: +12V with max 3A current
Operating Temperature
0~40
Operating Humidity 50~90%
AiMesh node
AiMesh node
NOTE: When you're using a wireless backhaul to connect your router and AiMesh
node, the WAN port on your AiMesh node can be used as a LAN port
providing up to 2.5G transmission speed.
USB 3.2 Gen 1x1
2.5G / 1G WAN port
2.5G / 1G
WAN port Connect your optical modem to this
port with a network cable.
LAN ports 1-3
Connect your PC to a LAN port with
a network cable.
o C Storage 0~70 o C
Storage 20~90%
AiMesh router
AiMesh Setup Steps
within
3 meters
AiMesh router