Mpow Bluetooth Headphones 059 Manual

Packages

Diagram

Pairing Function

1. With the headphone off, press the " " button for about 4~5 seconds, until the red and blue indicators take turns to flash.
2. Turn on the bluetooth function on your phone.
3. Search for the bluetooth devices and select " MPOW-059".

Play/Pause/Make a Call/Answer a Call/Hang up a Call/Reject a Call

Clearing Pairing Information

Volume Control/Music Control

Charge Battery

Safety Notice

• Do not disassemble or modify the headphone at any reason, otherwise, It may damage the headphone.
• Please keep the equipment along with all the accessories out of the reach of children and pets.
• Do not put the device under the environment which the temperature is too low or too high ( Below 0℃ or over 45℃).
• Please do not wet the device, for the liquid can cause serious damage to the device.
• Please do not operate the device in thunderstorm weather.

FCC Statement

Operation is subject to the following three conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
3. This device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one ormore of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

www.xmpow.com | support@xmpow.com

MPOW TECHNOLOGY CO., LTD
Copyright © MPOW Inc. All rights reserved.